Properly Using Liquid Detergent: Pour measured amount directly into the wash basket. For current models, it is recommended to add the detergent to the top of the load after adding clothes. You can also use part of the measured amount to treat stains before washing.
How do you use GE Spacemaker laundry?
GE Spacemaker Washer Instructions
- Sort laundry into like articles and place them loosely in the washtub.
- Slide the dispenser door latch to the right to unlock it.
- Turn the temperature knob to the right to select the wash and rinse cycle water temperature.
- Push in the wash cycle knob on the right of the control panel.
How do I reset my stackable GE washer and dryer?
To reset washing machines that use the GE Hydrowave system, start by unplugging the washer for one minute. Plug the washing machine back in and then within 30 seconds, quickly open and close the lid six times. You’ll need to do this within a 12-second period.
Where do I pour the liquid detergent in a washing machine?
Liquid Detergents: Measure using the cap and then pour either into the machine bowl or down the centre of the detergent drawer for most standard washing machines. Then add the clothes. Tip: In top loaders, do not put powder or liquid on top of clothes.
Why won’t my GE dryer heat up?
The high limit thermostat can cause GE dryers not to heat. This is most likely caused by the dryer vent being stopped up, so if the high limit is bad, check the vent. To check the high limit, first unplug dryer. Then take the top off by removing the two screws in the door (the only two pointing up) and lift up the top.
What should I do with my ge stackable washer dryer?
Open the dryer door, and pull the lint screen straight out. Remove any lint and replace the screen, ensuring that it goes back into the dryer the same way it came out and snaps into place. Do not rinse or wash the lint screen at any time. Add a dryer sheet into the dryer, if you wish. Load the dryer with wet clothes, and close the door firmly.
How do you change the wash cycle on a GE washer?
You can change the wash cycle and other settings on the GE washer at any time by pressing in on the “Cycle Selector” knob to stop the washer. Reset the GE washer knobs to the desired setting, and pull the “Cycle Selector” knob out to start the wash cycle again. Open the dryer door, and pull the lint screen straight out.
How do you add detergent to stackable washer?
Open the washer lid, and add detergent first for best results. Follow the directions on the detergent packaging for amount to use. Add the clothes that need washing. Do not overfill the washer with clothes, as this could cause an imbalance in the machine which will stop the wash cycle. Close the lid.
How do you dry clothes in a stackable washer and dryer?
Load the dryer with wet clothes, and close the door firmly. Ensure that the wet clothes have enough room to tumble freely in the dryer so that they dry evenly and completely. Turn the dryer “Cycle Selector” knob in either direction to the desired drying cycle.
